Crystal Epoxy is to enhance the value of the goods, protect the goods surface, play a decorative effect of chemical substances, so one would be self-defeating, but improper handling. Note the general procedure, but have to pay special attention to the following 4:01, the operation site and the work environment must be ventilated, and be sure to be done free of dust, debris, otherwise it will affect the transparency or colloid surface after curing glue spots effect. 2, Be sure to stir the glue, otherwise the surface will appear after curing resin shell pattern that lines, or the glue will not completely cured. 3, the glue must be weighed by weight accurate than, the imbalance will not dry or hard plastic glue becomes prolonged soft. 4, the relative humidity of the air environment control in less than 68% of the recommended site temperature 23-25 ??℃ appropriate. Work environment is too moist, then glue the surface will be oxidized into a mist or bubbles Nanxiao. Temperature is too low or too high and will affect the glue curing time, the glue droplets over the job thing you want to focus on the area to be dry, to be dry The temperature should be mastered at about 28 ℃ -40 ℃. If you want to know more information, please visit (Crystal Epoxy http://www.abjiao.cn) Website